HPE7-A08 Exam Guide & Practice Questions

Latest HPE7-A08 Exam Practice Questions

The practice questions for HPE7-A08 exam was last updated on 2026-10-08 .

Viewing page 1 out of 3 pages.

Viewing questions 1 out of 19 questions.

Question#1

Your network monitoring system has issued a critical alert indicating that the ISL between two VSX core switches is down.

What can you determine from the log output below?

A. Both switches are forwarding traffic over VSX lags.

B. Downstream switches are not able to forward traffic.

C. Keepalive packets are being dropped.

D. Core-2 has disabled its VSX lag interfaces.

Question#2

You have enabled PIM and IGMP querier function on a pair of VSX switches, but noticed that the secondary switch is always elected as the querier for all VLANs.
What could explain this behavior?

A. The primary switch has a higher MAC address.

B. The primary switch has a lower uptime.

C. The secondary switch has a higher VRRP priority.

D. The secondary switch has a lower IP address.

Question#3

An eBGP configuration is set up from HPE Aruba networking CX 6300 to two peers. Both peers advertise the 10.200.0.0/23 subnet with the default configuration.
What configuration implementation would prefer this route using peer A over B?

A. Define a route-map with set local-preference 200 and bind it to peer B BGP import configuration.

B. Define a route-map with set metric 200 and bind it to peer A BGP import configuration.

C. Define a route-map with set local-preference 200 and bind it to peer A BGP import configuration.

D. Define a route-map with set metric 200 and bind it to peer B BGP import configuration.

Question#4

Your customer’s CX switches are managed in HPE Aruba Networking Central. You plan to deploy new APs connecting to your existing CX switches.
Which report can you run to determine if there are enough available ports and PoE capacity?

A. Infra Inventory

B. Switch Capacity Planning

C. Network

D. Resource Utilization

Question#5

Your customer’s CX switches are managed in HPE Aruba Networking Central. They have recently deployed new cabling to some desks and want to be notified of any physical cabling issues.
Which alerts should you enable? (Choose two.)

A. Switch Port Input Errors

B. Switch Port Rx Rate

C. Switch Hardware Failure

D. Switch Uplink Port Usage

E. Switch Port Duplex Mode

Disclaimer

This page is for educational and exam preparation reference only. It is not affiliated with Hewlett Packard Enterprise (HPE), HPE Aruba Networking Certified Professional - Switching, or the official exam provider. Candidates should refer to official documentation and training for authoritative information.

Exam Code: HPE7-A08Q & A: 168 Q&As Updated: 2026-10-08

Get All HPE7-A08 Q&As

HPE7-A08 Exam Questions 2026 – Practice Test with Answers

Question#1

Question#2

Question#3

Question#4

Question#5

Top 20 Exams

Important Links

Know Us

Follow Us

Payment Methods