Latest HPE7-A09 Exam Practice Questions
The practice questions for HPE7-A09 exam was last updated on
2026-11-21
.
Viewing page 1 out of 7 pages.
Viewing questions 1 out of 36 questions.
Question#2
Why might an engineer decide to configure a switch using CLI instead of Aruba Central templates?
A. To enable AI-powered policy creation
B. To apply role-based segmentation
C. To make device-specific changes during initial deployment
D. To update device group assignments globally
Question#3
Which two symptoms usually point to a routing loop in an OSPF-enabled Layer 3 topology? (Select two answers)
A. High TTL values in traceroute
B. Frequent MAC address changes
C. Continual route flapping in routing table
D. Multiple equal-cost next-hops per route
Question#4
What is the best first step in diagnosing intermittent packet loss in a multi-tier AOS-CX network?
A. Disable spanning tree on all access ports
B. Monitor traffic using NetFlow
C. Inspect interface error counters on uplink ports
D. Reset OSPF neighbors
Question#5
Why should Equal-Cost Multi-Path (ECMP) be turned on in a Layer 3 core fabric?
A. It adds VLAN redundancy in Layer 2
B. It provides loop-free BGP routes
C. It enables load balancing across multiple next hops
D. It prevents route redistribution
Disclaimer
This page is for educational and exam preparation reference only. It is not affiliated with Hewlett Packard Enterprise (HPE), HPE Aruba Networking Certified Expert - Switching, or the official exam provider. Candidates should refer to official documentation and training for authoritative information.