NSE6_FSW-7.2 Exam Questions 2026 – Practice Test with Answers

Home / Fortinet / NSE6_FSW-7.2

Latest NSE6_FSW-7.2 Exam Practice Questions

The practice questions for NSE6_FSW-7.2 exam was last updated on 2026-11-21 .

Viewing page 1 out of 4 pages.

Viewing questions 1 out of 20 questions.

Question#1

Refer to the exhibits.






Port1 and port2 are the only ports configured with the same native VLAN 10.
For what two reasons can port1 be triggered to shut down? (Choose two.)

A. By loop guard protection, port1 was shut down.
B. STP triggered a loop and on port1 applied loop guard protection.
C. An endpoint sent a BPDU on port1 that it received from another interface.
D. On port 1, Loop guard frame sourced from port 1 was received.

Question#2

An administrator needs to deploy managed FortiSwitch devices in a remote location where multiple VLANs must be utilized to segment devices. No Layer 3 switch or router is present. The the only WAN connectivity is the router provided by the ISP connected to the public internet.
Which two items will need to be used by the administrator? (Choose two.)

A. A FortiSwitch interface connected to the ISP router with fortilink-13-mode configured as enabled.
B. FortiSwitch and FortiGate devices with VXLAN interfaces configured.
C. FortiSwitch devices with NAT configured as disabled.
D. FortiSwitch devices with the required internal hardware for this configuration.
E. FortiSwitch and FortiGate devices with IPsec interfaces configured.

Question#3

In what way is traffic routed on FortiSwitch?

A. Hardware-based routing on FortiSwitch is handled by the CP
B. FortiSwitch first looks up the hardware routing table and then the forwarding information base (FIB).
C. ASIC hardware routing can only handle dynamic routing, if supported.
D. While managed by FortiGate, Layer 3 routing can be configured on FortiSwitch.

Question#4

In what way are the 'by VLAN redirect MAC address quarantine' mode and the 'by redirect MAC address quarantine' mode on FortiGate similar?

A. Both modes move quarantined devices to the quarantine VLA
B. To block inter-VLAN traffic, both modes require firewall policies.
C. To the blocked firewall address group, both modes add quarantined device MAC addresses.
D. Both modes block intra-VLAN traffic by FortiGate automatically.

Question#5

Exhibit.



To successfully configure the options shown in the exhibit above, what conditions does a FortiSwitch need to have? (Choose two.)

A. The FortiSwitch model is equipped with a maximum of 54 interfaces.
B. A splitport into four 10Gbps interfaces is being enabled by the CLI commands.
C. The port full speed prior the split was 100G SFP+
D. To native VLAN, the split port can be assigned

Disclaimer

This page is for educational and exam preparation reference only. It is not affiliated with Fortinet, NSE 6 Network Security Specialist, or the official exam provider. Candidates should refer to official documentation and training for authoritative information.

Exam Code: NSE6_FSW-7.2Q & A:  56  Q&As Updated:  2026-11-21

  Get All NSE6_FSW-7.2 Q&As

Other Related Practice Questions