Real IT Certification Exams Questions & Dumps | Get Certified with CertQuestionsBank.com

Latest FCSS_NST_SE-7.4 Exam Practice Questions

The practice questions for FCSS_NST_SE-7.4 exam was last updated on 2025-06-01 .

Viewing page 1 out of 2 pages.

Viewing questions 1 out of 14 questions.

Question#1

Refer to the exhibit.

Which three pieces of information does the diagnose sys top command provide? (Choose three.)

A. The miglogd daemon is running on CPU core ID 0.

B. The diagnose sys top command has been running for 18 minutes.

C. The miglogd daemon would be on top of the list, if the administrator pressed m on the keyboard.

D. The cmdbsvr process is occupying 2.4% of the total user memory space.

E. If the neweli daemon continues to be in the R state, it will need to be manually restarted.

Question#2

Exhibit.

Refer to the exhibit, which shows a FortiGate configuration.
An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however the web filter is not inspecting any traffic that is passing through the policy.
What must the administrator do to fix the issue?

A. Disable webfilter-force-off.

B. Increase webfilter-timeout.

C. Enable fortiguard-anycast.

D. Change protocol to TC

Question#3

Which two statements about conserve mode are true? (Choose two.)

A. FortiGate enters conserve mode when the system memory reaches the configured extreme threshold.

B. FortiGate starts taking the configured action for new sessions requiring content inspection when the system memory reaches the configured red threshold.

C. FortiGate exits conserve mode when the system memory goes below the configured green threshold.

D. FortiGate starts dropping all new sessions when the system memory reaches the configured red threshold.

Question#4

Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

A. Strict RPF is enabled by default.

B. User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.

C. User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.

D. User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.

E. User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.

Question#5

Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output.
Why?